DISH Pro Switch DPH42 Hybrid Multiswitch

Description

Supports the installation of multiple Hopper, Joey, Wally and VIP receivers – Including any combination of two of these receiver types
Provides connections for up to four satellite feeds from a DISH Pro (DP) or DISH Pro Plus (DPP) LNBF
Alternately, the DPH42 satellite inputs may be fed by the "To Additional" switch (trunk) outputs of a DPP44 or DP34
Supports Hopper 3 receiver with a DP or DPP dish antenna
Approved for use to ground the dish system
The DPH42 has a hard plastic material inside the input and output ports that make it easy to align the center conductor of the coax cable when connecting
- Because the ports of the DPH42 are not self-sealing a CAP must be used on any unused ports to eliminate moisture migration
- Note that the CAPs that are provided with the DPH42 are different than the 75 Ohm terminators that are used to terminate unused client ports on a Node or DPH Hub
-
Do NOT
install 75 Ohm terminators on the DPH42
The DPH 42 Switch connects up to four satellite feeds from a DISH Pro (DP) or DISH Pro Plus (DPP) LNBF to Hopper®, Joey®, Wally®, ViP®, and DP receivers. Legacy receivers are not supported. Approved RG-6 cable required. Weather caps, not terminators, must be used for sealing off all unused ports on the switch.
Key Features:
Multiple Hopper, Joey, Wally, and ViP receivers, including a combination of two of these receiver types
Alaska, Hawaii and Puerto Rico installations; international customers
Customers requiring multiple satellite dishes
Multiple dwelling unit (MDU) customers
RG-6 cable rated between 950–3000 MHz
DOES NOT WORK with DISH Pro Hybrid LNBs. A standard DISH Western Arc or Eastern Arc LNB should be used instead
WARNING: CHOKING HAZARD
-- Small parts. Not for children under 3 yrs